You do this by pressing down on the latch at the top of the cyclone, then using a button on the side of the canister to release the cyclones.. Once you have separated the dust canister, you should.
On some vacuums, you can just slide off the drive belt without needing to remove the brush roll..Take a few photos of the brush bar before you remove it, just in case you forget how the various parts fit back together..
Step 4: Install the New Belt.Start by placing the new belt around the motor shaft, then thread the brush roll through the belt.. You’ll then need to reinstall the brushroll back into its original location.For flat or round belts, the tension required may require you to use a screwdriver to pry the end of the belt into the correct position..
Your New Belt Will (Probably) Look Too Small.Depending on the type of belt your vacuum uses, the new one may look or feel too small.
This is partly because the old belt will have stretched during use, but also because many vacuum belts are held in place through tension..
Even so, it’s a good idea to double check that the belt is the correct part for your vacuum’s model if you’re not sure that it fits.. Stretching is most common on flat or round vacuum belts.Coloured cloths may cause discoloration.
You should also work from the outside to inside to avoid spreading the stain..Try to clean up stains in carpets as soon as they happen.
The sooner you remove a stain, the easier the process will be.. Never vacuum a carpet that’s still damp from cleaning.Water could reach the motor, causing electrical damage and even risking an electric shock.. For chocolate stains, make sure you remove as much of the chocolate as possible with a blunt knife, then vacuum to remove loose pieces.